Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

140 Chapter7
Terminal and Printer Profiles
PAD Terminal Profile (Host-Based)
Fields Terminal type
The terminal type being associated with the profile.
The only valid terminal type for PAD terminal profiles
is terminal type 24.
Terminal type
file name A terminal type file created with the Workstation
Configurator utility (TTUTIL.PUB.SYS), to be
associated with the profile instead of the
system-supplied terminal type. Enter thefully qualified
file name (filename.group.account). Refer to the
Customizing Terminal and Printer Type Files with
Workstation Configurator for more information on
TTUTIL.PUB.SYS.
Record
width The number of characters for each record. For HP
terminals, the record width is usually 80 (the width of
the screen).
Allow :HELLO
logon? Specifies whether :HELLO logon will be accepted from
the terminals.
Reset HP
terminals? Specifies whether or not the terminal will be reset after
the DTC is powered on or after the connection is
aborted or re-established (for HP terminals only).
NLIO
device? Specifies whether native language devices will be used.
PAD test
requested? Specifies whether the DTC will set and read several
X.29 parameters at connection establishment time to
determine the PAD’s behavior.
Send initial
profile? Specifies whether at connection establishment, the
PAD is set to default X.3 terminal parameter values.
X.3 setting
requested? Specifies whether changes to X.3 parameters may be
made after connection establishment.
Forced data
forwarding? Specifies whether the Data Forwarding Parms #3 and
#4 will be allowed to change after connection
establishment. If this field is N then data forwarding
parms #3 and #4 can change if the port changes from a
normal read to VPLUS mode or if an Alternate End of