Configuring and Managing MPE/iX Internet Services (MPE/iX 6.5)

Chapter 10 167
HP WebWise MPE/iX Secure Web Server
Copying the Software to Your e3000
Copying the Software to Your e3000
The software may be electronically downloaded from HP Software Depot, ordered on
CDROM media, or ordered on DDS media.
If using DDS media, perform the follow steps to copy the software to your e3000:
1. :HELLO MANAGER.SYS
2. :FILE T;DEV=TAPE
3. :RESTORE *T;@.@.@;SHOW
4. The file /tmp/webwise-A0100.tar.Z will be restored to your e3000.
If using CDROM media, insert the media into the CDROM drive on your PC, Mac, or
Linux machine and locate the file
\HP_WebWise\MPE_iX_Secure_Web_Server\Software\webwise-A0100.tar.Z. You will
need to use ftp to upload this file (referred to as file.tar.Z in the example below) to your
e3000.
If you have electronically downloaded this software over the web, locate the downloaded
tar file on your hard disk. You will need to use ftp to upload this file (referred to as
file.tar.Z) to your e3000 as explained below.
The following example uses the Microsoft Windows command line ftp client to copy the
software to your e3000:
C:\TEMP> ftp your3000.host.name
Connected to your3000.host.name.
220 HP ARPA FTP Server [A0009C04] (C) Hewlett-Packard Co. 1990
User (your3000.host.name:(none)): MANAGER.SYS
331 Password required for MANAGER.SYS. Syntax: userpass
Password:********
230 User logged on
ftp> quote TYPE L 8 (also known as "local8" or "tenex" or "bytestream" mode)
200 Type set to L (byte size 8).
ftp> put file.tar.Z /tmp/webwise-A0100.tar.Z
200 PORT command ok.
150 File: /tmp/webwise-A0100.tar.Z opened; data connection will be opened
226 Transfer complete.
4400482 bytes sent in 74.00 seconds (59.47 Kbytes/sec)
ftp> quit
221 Server is closing command connection
If you use a method other than ftp to transfer the software to your e3000, it is critical to
make sure that the software is uploaded as a POSIX bytestream file, not as an MPE binary
or ASCII file.