Communicator e3000 MPE/iX Release 6.5 (Non-Platform Software Release C.65.00 (30216-90291)

Chapter 4 111
Data Center Management
TERMDSM: User Interface Change under System Diagnostics
Use of this program is subject to the licensing restrictions described
in “Help-->On Version”. HP shall not be liable for any damages resulting
from misuse or unauthorized use of this program.
cstm>
cstm> ru termdsm
-- Termdsm Utility. --
*******************************************************************
***** *****
***** TERMDSM *****
***** *****
***** (C) Copyright Hewlett Packard Co. *****
***** 1987, 1990, 1993, 1994 *****
***** All Rights Reserved. *****
***** *****
***** Version C.01.60 *****
***** *****
***** HP shall not be liable for any damages resulting from *****
***** the use of this program. *****
***** *****
***** Catalog AM.060 *****
***** *****
*******************************************************************
Welcome, Today is THU, AUG 19, 1999 at 4:02 PM
-- Utility : Section selection for TERMDSM. --
Enable Dialog For Additional Run Options? (y/n)[no]
Your system has these Distributed Terminal Controllers:
DTC Network
Number Address Name
------ ------------ --------------------
^
Use this number as the “DTC number” in Termdsm commands.
Connect DIag DTc DUmp EEprom Help Reset Status Trace EXit ?
--------------------------------------------------------------------
One addition to this menu driven tool is that MESA has more options to run the tool. For
now, this is not suggested for TERMDSM.
In the above query which appears right after the banner showing TERMDSM,
-- Utility : Section selection for TERMDSM. --
Enable Dialog For Additional Run Options? (y/n)[no].
It is suggested to user to say no in the above to directly proceed to the tool prompt since
there are no additional run options provided.
When the TERMDSM’s prompt appears, it runs the same way as it used to run under
SYSDIAG.