Communicator e3000 MPE/iX Release 6.0 Express 1 (C.60.01) (30216-90286)

54 Chapter3

Technical Articles

Legato 3000 NetWorker Storage Node for MPE/iX

by Alex Early

Commercial Systems Division

The HP 3000 NetWorker Storage Node for MPE/iX is supported in MPE/iX 6.0 Express 1.

The HP 3000 NetWorker Storage Node for MPE/iX allows the HP 3000 to support directly

connected DLT7000 libraries. The Storage Node requires additional Legato software,

NetWorker server software (NT or UNIX), and Autochanger license. With the Storage

Node, the HP 3000 supports DLT 1/8, 2/15, 2/28, 3/30, 4/48, etc... A complete list can be

found at http://www.hp.com/go/3000.

Conﬁguring Libraries on MPE/iX

To conﬁgure the DLT Library on an HP 3000, perform the following steps:

Step 1. After booting, run ODE at the ISL prompt:

ISL> ODE

NOTE

The MPE ISL ODE “RUN MAPPER” utility does not recognize and list

fast-wide robotics devices.

Step 2. Run mapper to get device paths:

ODE> RUN MAPPER

***STARTING EXECUTION OF MAPPER****

Processor Identification:

...I/O Configuration:

Type HW SW Revisions

Path Component Name ID Mod Mod Hdwr Firm

...

/4/4 HP-PB Fast Wide SCSI . . .

/4/4.0.0 C1194F . . .

/4/4.1.0 DLT7000 . . .

/4/4.2.0 DLT7000 . . .

/4/4.3.0 DLT7000 . . .

/4/4.4.0 DLT7000 . . .

Step 3. Boot the system. At the MPE prompt, run sysgen and start the io section:

: sysgen

SYSGEN version E . . .

sysgen> io

** IO configurator commands **