Asynchronous Serial Communications Programmer's Reference Manual (32022-90052)

288 AppendixA
Comparing MPE/iX Systems to MPE V Systems
Configuration
through the interface provided by the OpenView DTC Manager. For
more information on configuration with the OpenView DTC Manager
see Using the OpenView DTC Manager.
Terminal Configuration Settings
With several exceptions, terminal configuration settings for supported
terminals on MPE/iX systems are the same as the settings that were
used for supported terminals on MPE V systems. The following
configuration values are the only settings that you will need to change
so that the terminal will operate properly when connected to a DTC:
• RecvPace (Receive Pacing) must be set to XON/XOFF.
• XmitPace (Transmit Pacing) must be set to XON/XOFF.
Note that the EnqAck setting can be left on although the ENQ/ACK
protocol is not used.