APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Chapter 4 91
APPC Subsystem Configuration
Configuring the APPC Subsystem
After you enter the LU names into the “APPC: Dependent LU List
Data” screen, press
[f6] (Save Data), and then press [f8] (Prior Screen)
twice to get back to the “APPC: Select Session Type” screen. From
there, you can configure another session type, or you can press
[f8]
(Prior Screen) again to get back to the “APPC Configuration” screen.
Figure 4-10 Dependent LU List Data Screen
Fields
Local LU Names
The LUs you enter must be configured in the SNANODE
branch of NMMGR. The SNA node with which they are
associated in the SNANODE configuration must be the
same one specified in the SNA Node Name field of the
“APPC: Dependent LU Session Type Data” screen. See
the SNA Link/XL Node Manager’s Guide for
information on SNA node and LU configuration. A local
LU name can be up to 8 alphanumeric characters; the
first character must be alphabetic. For troubleshooting
purposes, Hewlett-Packard recommends that the
Local LU Names match the values in the
luname
operand of the LU macro on the IBM host.