APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Chapter 4 77
APPC Subsystem Configuration
Configuring the APPC Subsystem
Configuring the APPC Subsystem
This section describes the NMMGR screens used for APPC subsystem
configuration.
NOTE NMMGR will operate on a file of any legal name. However, the SNA
node will not activate unless the configuration file is named
NMCONFIG.PUB.SYS.
Main Screen
The NMMGR “Main” screen lets you select the category of network
subsystems you want to configure. The “Main” screen is shown in
Figure 4-2.
To go to the “HP-IBM Configuration” screen, press
[f4] (IBM).
Figure 4-2 Main Screen