APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

66 Chapter3
Control Operator Intrinsics
APPCStart
Return Codes 0 = Successful completion
-1002 = Parameter error
-1004 = Too many parameters specified
-1005 = Syntax error
-1006 = Redundant parameter
-1007 = Missing parameter after equal sign
-1008 = Missing or invalid delimiter
-1009 = Parameter out of bounds
-1010 = User missing NM capability
-1011 = Invalid value for Erropt parameter
-1012 = Invalid value for TraceOn parameter
-1013 = Invalid value for TFileSize parameter
-1014 = Invalid value for PerformanceOn parameter
-1030 = APPC module versions mismatch
-1031 = Missing required module
-1032 = Invalid module ID in version check
-1033 = Invalid remotely initiated transaction program name
-1034 = Invalid APPC configuration
-1035 = Unable to open NMCONFIG file
-1036 = Unable to close NMCONFIG file
-1037 = Configuration error
-1038 = Unable to open CATAPPC.APPC.SYS
-1039 = Unable to close CATAPPC.APPC.SYS
-1040 = Unable to open NM log file
-1041 = Unable to close NM log file
-1042 = Unable to open internal trace file
-1043 = Unable to close internal trace file
-1046 = Unable to create Resource Manager at subsystem
start-up
-1047 = Unable to create control operator TP at subsystem
start-up
-1048 = Unable to create CNOS TP at subsystem start-up
-1049 = Resource Manager detected error during subsystem
start-up
-1050 = COPR TP detected error during subsystem start-up
-1051 = CNOS TP detected error during subsystem start-up
-1063 = Resource Manager error - CHANGE_SESSIONS_FAILED
-1065 = Control Operator internal error
-1072 = APPC subsystem not active
-1073 = APPC subsystem pending active
-1074 = APPC subsystem already active
-1075 = APPC subsystem shutting down
-1201 = Session limit exceeded
-1202 = Catread failed