APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

46 Chapter2
Interactive Control Operator Commands
APPCCONTROL STATUS
In the following example, the APPCCONTROL STATUS command was
issued for one independent session type: STYPE1. The display includes
information about the active sessions of that session type and the
transaction programs running on those sessions.
:APPCCONTROL STATUS;STYPE=SESS1
Internal Trace File : NMTC0020.PUB.SYS
Performance Tracing : ON
---------------------------------------------------
Number of Active Sessions for APPC Subsystem : 5
---------------------------------------------------
Session Type Information :
---------------------------------------
Independent LU Session Type : STYPE1
---------------------------------------
Number of Active Sessions : 2
Number of Queued Session Requests : 3
Session Limits
Local LU SNA Node Remote LU Mode Maximum Current
-------- -------- ----------------- ------ ------- -------
INDLU1 SNANODE NET1.IBMLUA MODE1 50 50
Session ID LFSID State LU Type TP ID
---------- ----- -------- ------- -----
62 0000 1 ACTIVE PRI 1011
74 0000 2 ACTIVE PRI 6712
Transaction Program Information:
TP ID Program File Name TP Name # Conv. User Name
----- -------------------- --------- ------- ------------
1011 TP1.PUB.SYS TP1 1 JOE.USER
6712 TP2.PUB.SYS TP2 1 JOE.USER
If APPC subsystem internal tracing has been turned off, “TRACEOFF” is
displayed instead of the trace file name (NMTC0020.PUB.SYS, in the
example).