APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

34 Chapter2
Interactive Control Operator Commands
APPCCONTROL PERFORMANCE
SESS3 , LU = DEPLU8 , NODE = IBMNODE , SID = 2298
Session Started : FRI, JUN 20, 1990, 2:37 AM
Duration : 30 minutes 2 seconds
Bytes Sent = 1011
Bytes Received = 5
RUs Sent = 5
RUs Received = 1
Negative Responses Sent = 0
Negative Responses Received = 0
Avg. Remote Response Time (msec) = 0
Avg. CONFIRM Time (msec) = 0
Conversations Started = 0
Avg. bytes per Conversation = 0
Avg. Conversation Time (sec) = 0
Reading the Display
Each line of the APPCCONTROL PERFORMANCE display is described below:
Current Time
The time at which APPCCONTROL PERFORMANCE was
issued.
Subsystem Started
The time at which APPCCONTROL START was issued.
Duration
The length of time the APPC subsystem has been
active.
TPs Started per Subsystem
The number of transaction program processes started
since APPCCONTROL START was issued.
Session Type Name, LU Name, Node Name, and Session ID
The session type name, local LU name, and SNA node
name configured for this session type, and the session
identification number being used for the session. A
separate set of statistics will be seen for each active
APPC session for which performance data is requested.
Session Started
The time at which the APPC session was activated.
Duration
The length of time the APPC session has been active.