APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

27
2 Interactive Control Operator
Commands
This chapter describes the APPCCONTROL commands used to control
APPC subsystem functions.
NOTE For all releases of the APPC subsystem that do not support Node
Type 2.1, the APPCCONTROL commands are MPE commands interpreted
by the MPE command interpreter. However, for the Node Type 2.1
version of the APPC subsystem, the APPC subsystem has its own
command interpreter for APPCCONTROL commands.
For the Node Type 2.1 version, a system UDC file, which is installed
with the APPC subsystem, will translate APPCCONTROL commands into
MPE RUN commands that invoke the APPCCONTROL command
interpreter. Before you can issue any APPCCONTROL commands, you
must issue the following command to set the system UDC file:
SETCATALOG APPCUDC.APPC.SYS;SYSTEM;APPEND
You must have NM (Node Manager) or NA (Network Administrator)
capability to issue APPCCONTROL commands.
The commands in this chapter are listed alphabetically.