APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Appendix A 173
Messages
Return Codes
ACTION: Issue the APPCCONTROL VERSION command to determine
which software modules are installed on the system, and save the
output to a file. Call your HP representative.
-1032 MESSAGE: Invalid module ID in version check
CAUSE: The APPC subsystem detected NM return code 105 during
version checking.
ACTION: Issue the APPCCONTROL VERSION command and save the
output to a file. Contact your HP representative.
-1034 MESSAGE: Invalid APPC configuration
CAUSE: The APPC subsystem detected an error trying to validate the
configuration file during subsystem startup.
ACTION: Check the configuration of the APPC subsystem. If the
problem persists, contact your HP representative.
-1035 MESSAGE: Unable to open NMCONFIG file
CAUSE: The APPC subsystem is unable to open the NMCONFIG.PUB.SYS
file.
ACTION: Restart the APPC subsystem. If the same message is returned,
call your HP representative.
-1036 MESSAGE: Unable to close NMCONFIG file
CAUSE: The APPC subsystem is unable to close the NMCONFIG.PUB.SYS
file.
ACTION: Restart the APPC subsystem. If the same message is returned,
call your HP representative.
-1037 MESSAGE: Configuration error
CAUSE: The APPC subsystem detected an error return code from the
NMCONF call of Node Management Services.
ACTION: Check the configuration of the APPC subsystem.
-1038 MESSAGE: Unable to open CATAPPC.APPC.SYS
CAUSE: The APPC subsystem is unable to open the catalog file
CATAPPC.APPC.SYS.
ACTION: Type LISTF CATAPPC.APPC.SYS to see if the file exists. Call
your HP representative.
-1039 MESSAGE: Unable to close CATAPPC.APPC.SYS
CAUSE: The APPC subsystem is unable to close the catalog file
CATAPPC.APPC.SYS.
ACTION: Type LISTF CATAPPC.APPC.SYS to see if the file exists. Call
your HP representative.