APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

166 AppendixA
Messages
Error Messages
1063 MESSAGE: RESOURCE MANAGER ERROR — CHANGE SESSIONS
FAILED. (APPCERR 1063)
CAUSE: The APPC subsystem detected an internal error.
ACTION: Call your HP representative.
1064 MESSAGE: RESOURCE MANAGER ERROR — SUBSYSTEM
SHUTDOWN FAILED. (APPCERR 1064)
CAUSE: The APPC subsystem detected an internal error while trying to
shut down the APPC subsystem after the APPCCONTROL STOP command
was issued.
ACTION: Call your HP representative.
1065 MESSAGE: CONTROL OPERATOR (COPR) INTERNAL ERROR.
(APPCERR 1065)
CAUSE: The COPR TP detected a run-time error.
ACTION: Call your HP representative.
1066 MESSAGE: APPC OBJECT ACCESS ERROR. (APPCERR 1066)
CAUSE: The Control Operator was unable to access the APPC KSO.
ACTION: Call your HP representative.
1067 MESSAGE: UNABLE TO OPEN $STDIN. (APPCERR 1067)
CAUSE: The Control Operator was unable to open $STDIN to read from
the terminal.
ACTION: Call your HP representative.
1068 MESSAGE: UNABLE TO OPEN $STDLIST. (APPCERR 1068)
CAUSE: The Control Operator was unable to open $STDLIST to write
output to the terminal.
ACTION: Call your HP representative.
1071 MESSAGE: APPC PERFORMANCE TRACING NOT ENABLED.
(APPCERR 1071)
CAUSE: The APPCCONTROL PERFORMANCE command was issued when
APPC performance tracing was not active.
ACTION: Issue the APPCCONTROL PERFORMANCEON command to enable
the gathering of performance statistics before issuing the APPCCONTROL
PERFORMANCE command.
1072 MESSAGE: APPC SUBSYSTEM NOT ACTIVE. (APPCERR 1072)
CAUSE: The command issued cannot be executed because the APPC
subsystem was not started.
ACTION: If you wish to execute the command, do so after starting up the
APPC subsystem with the APPCCONTROL START command.