APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

162 AppendixA
Messages
Error Messages
1016 MESSAGE: INVALID SESSION LIMIT OR SUBSYSTEM'S LIMIT
EXCEEDED (APPCERR 1016)
CAUSE: Session limit specified in the LIMIT parameter of the
APPCCONTROL SESSIONS command is greater than the number
currently allowed.
ACTION: You could receive this message because you tried to exceed the
maximum number of sessions that the APPC subsystem can support, or
because you exceeded the number of sessions configured for this session
type. Check the number of active sessions and the configured session
limit for the session type by issuing the APPCCONTROL STATUS
command.
1017 MESSAGE: INVALID STOP_TYPE — [ K, P, OR Q ]. (APPCERR 1017)
CAUSE: Incorrect value assigned to the
TYPE parameter of the
APPCCONTROL STOP command.
ACTION: Check the syntax of this command by typing APPCCONTROL
HELP or by looking in Chapter 2 , “Interactive Control Operator
Commands,” of this manual.
1030 MESSAGE: VERSION NUMBER MISMATCH DETECTED.
(APPCERR 1030)
CAUSE: Type APPCCONTROL VERSION to verify the version mismatch.
Call your HP representative.
ACTION: Version mismatch detected between the modules.
1031 MESSAGE: MISSING REQUIRED APPC SUBSYSTEM MODULE
(APPCERR 1031)
CAUSE: A required file has not been installed on the subsystem.
ACTION: Issue the APPCCONTROL VERSION command to determine
which software modules are installed on the system, and save the
output to a file. Call your HP representative.
1032 MESSAGE: INVALID APPC SUBSYSTEM MODULES INSTALLED
(APPCERR 1032)
CAUSE: APPC subsystem detected NM return code 105 during version
checking.
ACTION: Issue the APPCCONTROL VERSION command, and save the
output to a file. Call your HP representative.
1034 MESSAGE: INVALID APPC SUBSYSTEM CONFIGURATION.
(APPCERR 1034)
CAUSE: The APPC subsystem detected an error trying to validate the
configuration file during subsystem startup.