APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

160 AppendixA
Messages
Error Messages
1003 MESSAGE: PARAMETER STRING LENGTH TOO LONG.
(APPCERR 1003)
CAUSE: Parameter string exceeded specified length.
ACTION: Check the syntax of this command by typing APPCCONTROL
HELP or by looking in Chapter 2 , “Interactive Control Operator
Commands,” of this manual.
1004 MESSAGE: TOO MANY PARAMETERS SPECIFIED. (APPCERR 1004)
CAUSE: An APPCCONTROL command was issued with too many
parameters.
ACTION: Check the syntax of this command by typing APPCCONTROL
HELP or by looking in Chapter 2 , “Interactive Control Operator
Commands,” of this manual.
1005 MESSAGE: SYNTAX ERROR — TYPE 'APPCCONTROL HELP' FOR
SYNTAX. (APPCERR 1005)
CAUSE: Incorrect syntax of command.
ACTION: Check the syntax of this command by typing APPCCONTROL
HELP or by looking in Chapter 2 , “Interactive Control Operator
Commands,” of this manual.
1006 MESSAGE: REDUNDANT PARAMETER. (APPCERR 1006)
CAUSE: A parameter has been used more than once.
ACTION: Retype the command, leaving out the duplicated parameter.
1007 MESSAGE: MISSING PARAMETER AFTER EQUAL SIGN. (APPCERR
1007)
CAUSE: A parameter was specified, but no value was assigned to it, or
there was a syntax error in the command line.
ACTION: Retype the command with the assigned value, or check the
syntax by typing APPCCONTROL HELP.
1008 MESSAGE: MISSING OR INVALID DELIMITER — USE “;” AS
DELIMITER. (APPCERR 1008)
CAUSE: Incorrect syntax of command.
ACTION: Check the syntax of this command by typing APPCCONTROL
HELP> or by looking in Chapter 2 , “Interactive Control Operator
Commands,” of this manual.
1009 MESSAGE: PARAMETER OUT OF BOUNDS IN PROGRAMMATIC
INTERFACE. (APPCERR 1009)
CAUSE: Programmatic interface detected a parameter out of bounds.
ACTION: Call your HP representative.