APPC Subsystem on MPE/XL Node Manager's Guide (30294-90007)

Appendix A 155
Messages
Logging Messages
48 MESSAGE: APPC: SECONDARY STATUS: INFO=!, SUBSYS=!
(APPCLOG 48).
CAUSE: This message follows another message and supplies the
subsystem number and the return code from the MPE XL intrinsic that
failed.
ACTION: See the message that was logged just before this one for more
information
49 MESSAGE: APPC: ! ! Limits Succeeded: OK AS SPECIFIED
(APPCLOG 49).
CAUSE: The requested session limits have been accepted as specified;
they were not negotiated.
ACTION: No action required.
50 MESSAGE: APPC: ! ! Limits Succeeded: OK AS NEGOTIATED
(APPCLOG 50).
CAUSE: The requested session limits have been negotiated successfully.
ACTION: No action required.
51 MESSAGE: APPC: ! ! Limits Failed: UNRECOGNIZED MODE NAME
(APPCLOG 51).
CAUSE: The mode name for the remote LU does not match the mode
name for the local LU.
ACTION: Check the APPC subsystem configuration to verify that the
mode name configured for the local LU is the same mode name
configured for the remote LU.
52 MESSAGE: APPC: ! ! Limits Failed: MODE SESSION LIMIT CLOSED
(APPCLOG 52).
CAUSE: The session limit on the IBM AS/400 was set to 0, and the
APPC subsystem attempted to raise the session limit.
ACTION: Start the mode on the AS/400.
53 MESSAGE: APPC: ! ! Limits Failed: COMMAND RACE REJECT
(APPCLOG 53).
CAUSE: CNOS requests from both the local and the remote systems
attempted to change the session limits at the same time. One or both
requests failed.
ACTION: Reissue the APPCCONTROL SESSIONS command. If this error
occurred at subsystem startup, restart the APPC subsystem.