Using the Node Management Services (NMS) Utilities (32022-90053)

246 AppendixA
NMS Error Messages
NMGR Error and Warning Messages
MESSAGE: RENAME requires a new node name and/or new
global/local setting. (NMGRERR 306)
NMGRERR 306 CAUSE: This is an informative message that is issued when the user
tries to rename a node name (global/local setting), but both the new
node name and new global/local setting were omitted.
ACTION: Specify the missing information.
MESSAGE: The current node name entry has been deleted by another
user. (NMGRERR 307)
NMGRERR 307 CAUSE: The user attempted to delete or update a network address, or
path data, but another user who is modifying the same directory file
has just deleted the entry.
ACTION: Coordinate update activities with other user(s).
MESSAGE: Duplicate IP address. (NMGRERR 308)
NMGRERR 308 CAUSE: The user attempted to add a network address that already
exists in the current path report.
ACTION: Either choose a different network address, or make sure you
are updating the correct node name global/local setting.
MESSAGE: Not enough room in the path report list for this addition.
(NMGRERR 321)
NMGRERR 321 CAUSE: This is an informative message that is issued when the user
attempts to add or update a path in a very large path report list. This
can happen only on very large gateway nodes, such as a node with more
than 15 network addresses.
ACTION: See “Submitting an SR” at the beginning of this appendix.
(Request an expansion on the limit on path reports.)
MESSAGE: Internal NMMGR error — corrupt path report list data.
(NMGRERR 322)
NMGRERR 322 CAUSE: Severe error indicating an internal logic error.
ACTION: See “Submitting an SR” at the beginning of this appendix.
MESSAGE: No directory file open. (NMGRERR 323)
NMGRERR 323 CAUSE: Maintenance mode interface: An informative message that is
issued when a user gives a command prior to completing a successful
OPENDIR command.
ACTION: Open or create a directory file using OPENDIR, then reissue
the command.