Using the Node Management Services (NMS) Utilities (32022-90053)

244 AppendixA
NMS Error Messages
NMGR Error and Warning Messages
MESSAGE: Internal ERROR in subtree copy. (NMGRERR 284)
NMGRERR 284 CAUSE: Internal error.
ACTION: See “Submitting an SR” at the beginning of this appendix.
MESSAGE: A non select screen id was changed in the destination
path. (NMGRERR 285)
NMGRERR 285 CAUSE: Incorrect ids in the destination path.
ACTION: See “Submitting an SR” at the beginning of this appendix.
MESSAGE: Illegal path name identifier in destination path name.
(NMGRERR 286)
NMGRERR 286 CAUSE:A path id in the destination pathname is not legal.
ACTION: Check the destination path id for typing mistakes.
MESSAGE: Invalid destination path — path too long. (NMGRERR 287)
NMGRERR 287 CAUSE: The source and destination paths must be the same length.
When entering data on the subtree copy screen, the source path may
appear longer, but should this be the case, the destination path uses
IDs from the source path. This error is generated in the other case
when the destination path is longer than the source path.
ACTION: Check to make sure that you are not missing path ids in the
source path.
MESSAGE: Source path contains empty path identifiers.
(NMGRERR 288)
NMGRERR 288 CAUSE: This occurs when the user leaves path IDs empty in the middle
of the source path field on the copy subtree screen.
ACTION: Check the source path, and fix the path, so that none of the
source path IDs in the middle of the source path are blank.
MESSAGE: The source and destination may not be the same file and
path. (NMGRERR 289)
NMGRERR 289 CAUSE: The user is attempting to copy over the source data, which is
not allowed.
ACTION: Select another file or path to copy into.
MESSAGE: The file does not exist or cannot be opened.
(NMGRERR 290)
NMGRERR 290 CAUSE: An NMCONF file to be opened for a copy could not be accessed.
ACTION: Check the spelling of the filename. Do a “listf <filename>“ to
see if file exists.