Using the Node Management Services (NMS) Utilities (32022-90053)

Appendix A 243
NMS Error Messages
NMGR Error and Warning Messages
MESSAGE: Duplicate address key; it must be unique for the X.25 NI.
(NMGRERR 277)
NMGRERR 277 CAUSE: The user specified an address key that was not unique for the
NI specified at the VC Configuration screen or through the ADDVC
command.
ACTION: Go to the SVC and PVC paths screens for the NI to see the
names that are already configured. Choose an address key that is not
used in either of these screens.
MESSAGE: Missing quote; the IP address must be enclosed in
quotes. (NMGRERR 278)
NMGRERR 278 CAUSE: While using the ADDVC command in maintenance mode, the
user forgot to enter the IP address with either an opening or a closing
quote.
ACTION: Re-issue the command with the correct IP address enclosed in
quotes.
MESSAGE: The source path was not found. (NMGRERR 280)
NMGRERR 280 CAUSE: The path to the subtree to copy was not found.
ACTION: Check to make sure you have the correct file and check the
source path spelling.
MESSAGE: The destination path was not found. (NMGRERR 281)
NMGRERR 281 CAUSE: The destination path, which is created by substituting any
destination IDs into the source path, was not accessible. The path in the
file was not an exact match, or the destination path was missing.
ACTION: Check the source and destination path spelling and make
sure you have the correct file.
MESSAGE: The destination path exists. Use the overwrite option to
replace. (NMGRERR 282)
NMGRERR 282 CAUSE: The destination path already exists in the file.
ACTION: Enter ‘Y’ in the overwrite option.
MESSAGE: Source and destination do not map with each other
correctly. (NMGRERR 283)
NMGRERR 283 CAUSE: The source and destination paths must start at the same spot
in the NMMGR schema. Most likely the user attempted to change the
name of an item in the destination of a subtree copy.
ACTION: Check to see if the item that was changed was a select or type
select identifier. If not, that will cause the subcopy to fail.
Check to make sure that any destination type select items, if changed,
were changed to items of the same type (as in LAN to LAN, instead of
LAN to router).