Using the Node Management Services (NMS) Utilities (32022-90053)

240 AppendixA
NMS Error Messages
NMGR Error and Warning Messages
ACTION: If an incorrect DTC name was entered, enter the correct DTC
name and try again. If the DTC name is correct but the DTC has not yet
been configured, enter the information for the DTC and press the Save
Data key, then try again.
MESSAGE: The DTS Link does not exist. Enter a Link name and press
Sate Data. (NMGRERR 261)
NMGRERR 261 CAUSE: At the DTS Configuration screen, the user entered a
nonexisting link name and pressed the Tune DTS Link key.
ACTION: If an incorrect link name was entered, enter the correct link
name and try again. If the link name is correct but the link has not yet
been configured, enter the information for the link and press the Save
Data key, then try again.
MESSAGE: Must be a number from 0 to 5. (NMGRERR 262)
NMGRERR 262 CAUSE: At the DTC Configuration screen, the user entered an invalid
character in the field specifying the card to be configured and pressed
the Config Card key.
ACTION: Enter the number of the card to be configured and press
Config Card again. The number must be between 0 and 5 and must
correspond to the DTC slot number of the card being configured.
MESSAGE: Data saved, but the home Network Interface does not
exist. (NMGRERR 263)
NMGRERR 263 CAUSE: The user specified a nonexisting NI name as the home network
interface and saved the data on the screen.
ACTION: If an incorrect NI name was specified, correct the NI name
and press Save Data again. If the NI name is correct but the NI has not
yet been configured, configure the NI. There is no need to re-enter the
information on the current screen since it has already been saved.
MESSAGE: Data saved, but the SNA does not exist. (NMGRERR 264)
NMGRERR 264 CAUSE: The user specified a nonexisting SNA node and saved the data
on the screen.
ACTION: If an incorrect SNA node was specified, correct the SNA node
name and press Save Data again. If the SNA node name is correct but
the SNA node has not yet been configured, configure the SNA node.
There is no need to re-enter the information on the current screen since
it has already been saved.
MESSAGE: This link name does not exist for this router NI.
(NMGRERR 265)
NMGRERR 265 CAUSE: The user entered a nonexisting link name and pressed the Link
Routing key.