Using the Node Management Services (NMS) Utilities (32022-90053)

214 AppendixA
NMS Error Messages
NMGR Error and Warning Messages
ACTION: See “Invalid Software Installation” at the beginning of this
appendix.
CAUSE: A file equation exists for NMMGRCAT.PUB.SYS.
ACTION: Check for file equations using LISTEQ2.PUB.SYS and RESET
if necessary.
CAUSE: The table of commands in the NM catalog file NMCAT.PUB.SYS
is corrupt or missing. File NMCAT.PUB.SYS is not a valid catalog file, or
it has become corrupted.
ACTION: Restore a back-up copy of NMMGRF.PUB.SYS.
CAUSE: The table of commands in the NM catalog file NMCAT.PUB.SYS
is corrupt or missing. Set 7 of NMCAT.PUB.SYS (the command set) is
missing, or some commands have been deleted from this set.
ACTION: Restore a back-up copy of NMMGRF.PUB.SYS.
MESSAGE: Missing data: NM config file corrupt or bad version.
(NMGRERR 15)
NMGRERR 15 CAUSE: NMMGR was unable to locate type code in data record.
ACTION: Restore an old version of the configuration file if possible, or
delete and reconstruct the corrupt link data record.
MESSAGE: Cannot set up form for next screen. (NMGRERR 16)
NMGRERR 16 CAUSE: The forms file NMMGRF.PUB.SYS may be missing or corrupt.
ACTION: Go to the Errors screen and check any other errors which are
displayed. See “Invalid Software Installation” at the beginning of this
appendix.
CAUSE: A terminal I/O error may have occurred. A user may have
entered :EOF or :EOD in response to the prompt “Press RETURN when
done viewing contents,” thereby closing the terminal for further input.
ACTION: Check the state of the terminal. Run NMMGR again if the
terminal is closed for input.
CAUSE: A data record may be corrupted, making it impossible for
NMMGR to display it.
ACTION: Go to the Errors screen and check any other errors which are
displayed. See “Invalid Software Installation” at the beginning of this
appendix.
CAUSE: NMMGR was unable to display the form for the screen which
the user selected. An internal VPLUS/3000 or NMCONF error may
have occurred.
ACTION: Check the version of VPLUS/3000 and NMCONF and restore
back-up copies if necessary.