Using the Node Management Services (NMS) Utilities (32022-90053)

Chapter 5 123
Using NMMGR in Maintenance Mode
READALLCONF
READALLCONF
Reads all data from the current configuration record.
Syntax READALLCONF [;FORMAT]
Parameters FORMAT Designates output formatting. Output is formatted in a
WRITECONF format so that it can be re-entered into
NMMGR’s maintenance mode. If the format option is
omitted, data will be formatted with one field per line
when writing to a file.
Description READALLCONF reads and displays all the fields in the configuration
record identified by the current path. If the current path is associated
with a multipaged data screen, then all the pages of data associated
with the screen are displayed, unless PAGECONF was used to set the
current page.
Output is directed to the file defined in the file equation FORMLIST. If
FORMLIST is not defined, output is sent to $STDLIST.
You must enter the CARDCONF, then the PATHCONF command before
using the READALLCONF command. This defines the pathname of the
record from which the data will be read. If you want READALLCONF to
display the data written in the previous WRITECONF commands, you
must first enter the UPDATECONF command.
If you are referencing a DTC card screen, you must use the CARDCONF
command to set the current card number before issuing the
READALLCONF command.
Example To display all the fields in the NETXPORT.NI.GLOBAL screen:
NMMGR> PATHCONF NETXPORT.GLOBAL
(Sets the path to the screen.)
NMMGR> READALLCONF
Displays all the fields in the screen.)
NMMGR> PATHCONF NETXPORT.GLOBAL
(Sets the path to the screen.)
NMMGR> READALLCONF;FORMAT
(Displays all the fields in the screen.)
PATHCONF NETXPORT.GLOBAL
WRITECONF HOMENET, “NETNAME”
WRITECONF F, “2”