Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

80 Chapter 4
TermDSM Commands
R[ESET] V[C]
R[ESET] V[C]
Resets the specific VC on an X.25 card in a specific DTC. (If the VC you
are attempting to dump is a PAD VC, you must use the Ldev option
instead.)
Security level: 2.
Syntax
V[C] dtcnum,cardnum,vcnum
Parameters
dtcnum Number of the DTC that contains the X.25 card (SNP).
This is the number TermDSM associates with this
DTC.
cardnum Number of the X.25 card within the DTC. The cards are
numbered from zero beginning at the bottom of the
DTC. (Note that SNP cards may not be mounted in slot
0 or 1 for DTC 16, and slot 0 for DTC 48.)
vcnum Number of the VC on the X.25 card within the DTC. On
a DTC 48 or DTC 72MX, up the 256 VCs are supported.
On a DTC 16, up to 32 VCs are supported. (PAD VCs
must be reset using the Ldev option.)
Description
When the subcommand is entered, the specified VC on an X.25 card is
reset. Any job or session running on the VC will be aborted.