Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

128 Appendix A
TermDSM Messages
MESSAGE: The call has been accepted by another node on the
network. Verify the correct configuration of the X25 address.
(TDSM 801)
(TDSM 801) CAUSE: The user was attempting to perform a loopback test, but the
connection was accepted by a different node on the network. This could
happen if the X.25 address configured for loopback belongs to a
different system instead of the local system.
ACTION: Run NMMGR and correct the X.25 address configured for
loopback on the level 3 configuration screen.
MESSAGE: The call has been refused by the network. Verify the
address configuration and the number of VCs configured. (TDSM 802)
(TDSM 802) CAUSE: The user was attempting to perform a loopback test on an SNP
card but the network would not accept the call.
ACTION: Run NMMGR to correct any problems with the DTC/X.25
Network Access card (SNP card) configuration.
MESSAGE: Bad card. (TDSM 803)
(TDSM 803) CAUSE: The DTC/X.25 Network Access card (SNP) being tested is bad.
ACTION: Contact your HP support representative.
MESSAGE: All ports are bad. (TDSM 804)
(TDSM 804) CAUSE: All ports on the DTC/X.25 Network Access card (SNP) being
tested are bad.
ACTION: Contact your HP support representative.
MESSAGE: Some ports are bad. (TDSM 805)
(TDSM 805) CAUSE: Some ports on the DTC/X.25 Network Access card (SNP) being
tested are bad.
ACTION: Contact your HP support representative.
MESSAGE: Unknown Cable. (TDSM 806)
(TDSM 806) CAUSE: TermDSM does not recognize the cable interfacing the
DTC/X.25 Network Access card (SNP card) to the network.
ACTION: Replace cable with a supported network interface cable.