Troubleshooting Terminal, Printer and Serial Device Connections - Edition 4 (32022-90030)

104 Appendix A
TermDSM Messages
MESSAGE: Your answer must be at least 1 and no more than 65535.
(TDSM 56)
(TDSM 56) CAUSE: The value entered is not in the range 1 to 65535.
ACTION: Enter a value in the range. Diagnostic loop counts are limited
to this range.
MESSAGE: Please deliver the following SNP dump to your HP
representative. (TDSM 63)
(TDSM 63) CAUSE: Informational message.
ACTION: Document the problem (the reason you took the dump), and
deliver it to your HP support representative along with the dump file,
preferably on magnetic tape.
MESSAGE: The following two files make up the DTC dump. Please
deliver both to your HP representative. (TDSM 64)
(TDSM 64) CAUSE: Document the problem (the reason you took a dump), and
deliver it to your HP support representative along with the dump files,
preferably on magnetic tape.
ACTION: Please deliver the following VC dump to your HP
representative. (TDSM 65)
MESSAGE: Please deliver the following VC dump to your HP
representative. (TDSM 65)
(TDSM 65) CAUSE: Informational message.
ACTION: Document the problem (the reason you took a dump), and
deliver it to your HP support representative along with the dump files,
preferably on magnetic tape.
MESSAGE: There are no DTCs configured on your system. (TDSM 70)
(TDSM 70) CAUSE: Necessary configuration information does not exist on the
system.
ACTION: Check the NMCONFIG.PUB.SYS file for proper DTC
configuration (using :NMMGR). Bring the system down and back up
again. If the problem persists, contact your HP support representative.
MESSAGE: There are more DTCs on your system than TermDSM can
reference. Here are the ones TermDSM can reference. (TDSM 71)
(TDSM 71) CAUSE: You are using more than 120 DTCs on the system. You will not
be able to perform any TermDSM functions on any DTCs that are not
listed in this message.
ACTION: Contact your HP support representative.