SNA NRJE Node Managers Guide (30292-90007)

Chapter 6 99
Commands
NRJE Manager Commands
NRJE Manager Commands
Most subsystem commands are available only to NRJE managers
(users with NM capability). Users without NM capability can have
access to the console commands, provided that one or more of the
commands have been “allowed” in the NRJE configuration file. (This is
described later in this chapter.) Table 6-2 summarizes NRJE manager
commands.
Table 6-2 NRJE Manager Commands
Command Function
CONSOLE Obtains access to the host remote console of a workstation.
HALT Stops active LU-LU sessions immediately.
PURGE
Purges entries in the NRJE Joblog.
This command does not apply if you are connected to a
VSE/POWER host system.
RDRDOWN
Disables the reader of an NRJE workstation.
RDRFENCE
Updates the outfence value of the NRJE workstation reader.
RDRUP Enables the reader of an NRJE workstation.
RELEASE Relinquishes access to the host remote console of a workstation.
RELOAD Causes NRJE to reload the Formid Lookup Table.
STARTWS
Starts a workstation or individual LUs, and optionally starts
intrinsic and/or LU tracing.
STATUS Displays the current status of LU sessions.
STOPWS Stops active LU-LU sessions in an orderly manner.
TRACEOFF Turns off intrinsic and/or LU tracing for a workstation.
TRACEON Turns on intrinsic and/or LU tracing for a workstation.
VERIFY Verifies the entries in the Formid Lookup Table.
WELCOME Updates the NRJE subsystem welcome message.
[] ... A host job entry system console command preceded by the host
command prefix character configured for the workstation.