SNA NRJE Node Managers Guide (30292-90007)

Chapter 6 91
Commands
NRJECONTROL START
If you omit this parameter, a default of 1024 is used.
Description
When the NRJECONTROL START command is issued, the NRJE monitor
is streamed and runs as an MPE job. (See Chapter 4 , “NA NRJE
Workstation Startup and Shutdown,” of this manual.) You can start a
workstation or individual LUs.
If you do not specify any
LUNames , all LUs configured to be initially
started are started. If you specify
LUName , only those LUs are started.
You also can start intrinsic and/or LU tracing (with the
Type
parameter) with this command. Note that LU tracing can be started for
an active workstation only.
NOTE If an error occurs because of a bad trace parameter, the workstation or
LUs will not start.
Text Reference
See STARTWS later in this chapter. NRJEStartWS is the manager
intrinsic counterpart of this command; it is described in the SNA NRJE
User/Programmer Reference Manual.