SNA NRJE Node Managers Guide (30292-90007)

86 Chapter6
Commands
MPE Commands
MPE Commands
Described below, in alphabetical order, are the MPE commands for SNA
NRJE. You must have MPE node manager (NM) capability to use these
commands. Table 6-1 summarizes the function of each command.
Table 6-1 MPE Commands for SNA NRJE
Command Function
NRJECONTROL HALT Stops active LU-LU sessions immediately.
NRJECONTROL START
Starts a workstation or individual LUs, and optionally
starts intrinsic and/or LU tracing.
NRJECONTROL STOP
Stops active LU-LU sessions in an orderly manner.
NRJECONTROL TRACEOFF Turns off intrinsic and/or LU tracing for a workstation.
NRJECONTROL TRACEON Turns on intrinsic and/or LU tracing for a workstation.
NRJECONTROL VERSION Lists the version numbers of SNA NRJE software.