SNA NRJE Node Managers Guide (30292-90007)

Chapter 3 51
SNA NRJE Configuration
Configuring SNA NRJE
Output Destination
Required. The default destination for output received
on the writer. Enter an MPE device class specification
(eight alphanumeric characters or less), an ldev
number of a spooled device, or a formid (in single
quotes). Use the formid to specify a Lookup Table entry
that defines the default output device characteristics.
Forced
Required. Enter Y if the formid specified in the
Output Destination field is to be used for all job
output (standard form and non-standard form) from
this writer. Note that you can enter Y only if you have
specified a formid in Output Destination. Enter N if
all output management routing requests (special forms
designations in the host JCL) received on the writer are
to be honored. This field does not affect job
management output routing requests (that is, routing
designations given as part of the SUBMIT command).
Default: N
Output Priority
Required. The priority for output from this writer.
Range: 1 – 14 (integer)
Default: 8
Translation Indicator
Required. The type of translation NRJE will perform
on data sets received from the host:
• -1 = No translation
SNA NRJE will write whatever it receives from the
host without translation.
• 0 = Native–3000 Translation
SNA NRJE will use the Native–3000 translation
table to translate data received from the host. You
also must have specified 0 for the Translation
Indicator field on the NRJE Configuration: Reader
Data screen.
• 1 – 255 = Native Language ID
An integer that corresponds to 8-bit languages other
than Native–3000. SNA NRJE will use the
translation table for the designated native language
to translate data received from the host. You also