SNA NRJE Node Managers Guide (30292-90007)

248 AppendixA
Result Codes and Messages
SNA NRJE Logging Messages
9102 MESSAGE: NRJE(!:!): WARNING: OUT OF MESSAGE FRAMES FOR
REMOTE CONSOLE FACILITY; (NUM FREE=!) (NUM NEEDED=!)
(LU=9102)
CAUSE: An NRJE LU has console data from the host to deliver to one or
more console users but the number of available message frames in the
ports facility is insufficient. This message is repeated every 60 seconds
until sufficient message frames become available. All NRJE activity
will suspend until the console message can be delivered.
ACTION: Check any application programs which may have opened the
console (with NRJEConsole) but has failed to receive messages using
the NRJERcvMsg intrinsic.
9103 MESSAGE: NRJE(!:!): INTRINSIC ERROR (INTR=!) (LU=9103)
CAUSE: A call to an NRJE intrinsic (such as NRJEConsole) failed.
ACTION:
9104 MESSAGE: NRJE(!:!): CANNOT OPEN ‘TEMP STORAGE’ DISC FILE.
(LU=9104)
CAUSE: FOPEN returned CCL on a the file.
ACTION: Refer to the preceding file system error message logged by
NRJE.
9105 MESSAGE: NRJE(!:!): FATAL ERROR WHILE ATTEMPTING TO
ACCESS AN OUTPUT SPOOLFILE. (STATUS=!) (LU=9105)
CAUSE: File system error occurred on the output file.
ACTION: Refer to the preceding file system error message logged by
NRJE.
9106 MESSAGE: NRJE(!:!): INTERNAL ERROR WHILE ACCESSING
OUTPUT SPOOLFILE. (LU=9106)
CAUSE: NRJE cannot setup for multirecord access to an output spool
file.
ACTION: Refer to the file system error message logged immediately
prior to this message.
9107 MESSAGE: NRJE(!:!): WARNING: CANNOT ALTER PRIORITY OF
OUTPUT SPOOLFILE. (LU=9107)
CAUSE: NRJE could not temporarily change the priority of an output
spool file to 1 while attempting to set up for multi-record access to the
output spool file.
ACTION: Contact Hewlett-Packard.