SNA NRJE Node Managers Guide (30292-90007)

Appendix A 231
Result Codes and Messages
SNA NRJE Logging Messages
8001 MESSAGE: NRJE(!;!): SNACLOSEUSER FAILED; RESULT=!
(LUX=8001)
CAUSE:
ACTION:
8002 MESSAGE: NRJE(!;!): AUTORECOVERY CONFIGURATION CHECK
FAILED; RESULT=! (LUX=8002)
CAUSE:
ACTION:
8003 MESSAGE: NRJE(!;!): SNARCV FAILED ON RECOVERY; RESULT=!
(LUX=8003)
CAUSE:
ACTION:
8004 MESSAGE: NRJE(!;!): NAU FAILED TO ACTIVATE ON RECOVERY;
RESULT=! (LUX=8004)
CAUSE:
ACTION:
8005 MESSAGE: NRJE(!;!): SNAOPENUSER FAILED; RESULT=!
(LUX=8005)
CAUSE:
ACTION:
9000 MESSAGE: NRJE(!:!): WARNING: FAILURE TO LOAD WRITER EXIT
PROCEDURE: ‘!’. INTERNAL BANNER DECODE ROUTINE WILL BE
USED. (LOAD ERR=!) (LU=9000)
CAUSE: NRJE was configured to use an external procedure for a logical
writer but the attempt to load the procedure failed.
ACTION: Refer to the MPE Intrinsics Reference Manual for information
on LOAD ERR.
Ensure that the exit procedure is in SL.NRJE.SYS or SL.PUB.SYS and
that the Writer Data screen indicates the correct procedure name.
Ensure that the RUN command in the NRJE stream file runs the
NRJEMON program with “LIB=G”.
9001 MESSAGE: NRJE(!:!): FAILED TO ACCESS CONFIGURATION FILE.
(CFG=!) (LU=9001)
CAUSE: NRJE failed to access the MIDAS database which returned an
error number of ‘CFG’.
ACTION: Ensure that the configuration file exists as
NMCONFIG.PUB.SYS. It may be necessary to convert the configuration