SNA NRJE Node Managers Guide (30292-90007)

192 AppendixA
Result Codes and Messages
SNA NRJE Error Messages
ACTION: Check the parameter list, add to it, and re-enter the data.
732 MESSAGE: WARNING: EXTRA PARAMETERS ARE DETECTED AND
IGNORED. (CI=732)
CAUSE: There are too many parameters.
ACTION: No action is required. If this error message was printed
because of prestored input, delete the extra parameters to prevent this
message from being printed again.
733 MESSAGE: UNABLE TO PARSE THE COMMAND. (CI=733)
CAUSE:
ACTION:
734 MESSAGE: THE CONSOLE MUST BE OPENED PRIOR TO USING THIS
COMMAND. (CI=734)
CAUSE: An attempt was made to RELEASE the console when it was not
open.
ACTION: Issue a CONSOLE command, or call NRJEConsole, then enter a
host console command or call NRJESendCmd.
735 MESSAGE: WORKSTATION ID IS EXPECTED. (CI=735)
CAUSE: A workstation identification was omitted from this command
and there is no default workstation. The NRJE subsystem was entered
without specifying a workstation identification.
ACTION: Re-enter this command including a workstation identification
parameter. Or enter an NRJE command with a workstation
identification parameter to establish a default workstation, and then
enter this command.
736 MESSAGE: UNABLE TO READ WELCOME MESSAGE INPUT. (CI=736)
CAUSE: NRJE command interpreter unable to read input welcome
messages from the user. A file system error should follow to clarify the
situation.
ACTION: Investigate the file system error message and if possible
reenter.
737 MESSAGE: END OF INPUT FILE DETECTED, SUBSYSTEM IS
TERMINATING... (CI=737)
CAUSE: NRJE command interpreter received an end of file condition
from MPE file system when attempting to read user input.
ACTION:
738 MESSAGE: UNDEFINED MPE COMMAND. (CI=738)
CAUSE: An undefined MPE command was entered from the NRJE
subsystem.