SNA NRJE Node Managers Guide (30292-90007)

Appendix A 179
Result Codes and Messages
SNA NRJE Error Messages
431 MESSAGE: UNABLE TO OBTAIN PORTS FACILITY XDS FOR NRJE
IPC. (INT=431)
CAUSE: NRJE was unable to obtain an extra data segment for use in
the ports facility to provide interprocess communication between the
several NRJE processes.
ACTION: Verify that all versions are correct. Increase the size of the
DST table using SYSDUMP (SYSTEM TABLE CHANGES). Refer to
the SNA Link Services Reference Manual for system configuration
information.
501 MESSAGE: WORKSTATION ! IS NOT IN THE PENDING STATE.
(MON=501)
CAUSE: Attempted to run NRJE monitor (NRJEMON) without calling
NRJEStartWS or issuing a STARTWS command.
ACTION: Call NRJEStartWS or issue STARTWS command.
502 MESSAGE: UNABLE TO SET THE ABORT TRAP. SEVERE ERROR.
(SEV=502)
CAUSE:
ACTION:
503 MESSAGE: WORKSTATION LENGTH IS NOT BETWEEN 1 AND 8
CHARACTERS. (MON=503)
CAUSE: NRJE monitor (NRJEMON) is run with the Info parameter
containing an invalid workstation name length.
ACTION: Rerun NRJEMON with a valid and existing workstation
name. Note: NRJEStartWS intrinsic must have been previously called or
STARTWS command previously issued.
505 MESSAGE: UNABLE TO READ DATA FROM “TO MONITOR”
MESSAGE FILE. (SEV=505)
CAUSE:
ACTION:
506 MESSAGE: UNABLE TO PURGE “TO HOST” CONSOLE MESSAGE
FILE. (SEV=506)
CAUSE: “TO HOST” console message file is being opened by an NRJE
operator and NRJE monitor is terminating.
ACTION: Locate the operator and tell it to close the file.
507 MESSAGE: UNABLE TO PURGE “FROM HOST” CONSOLE MESSAGE
FILE. (MON=507)
CAUSE: “FROM HOST” console message file is being opened by an
NRJE manager and NRJE monitor is terminating.