SNA NRJE Node Managers Guide (30292-90007)

170 AppendixA
Result Codes and Messages
SNA NRJE Error Messages
290 MESSAGE: INVALID USERNAME. (INT=290)
CAUSE: The username in the SHOW command or the NRJEHJInfo
intrinsic parameter is not in the proper form for a UserName.AcctName
or @.
ACTION: Correct the username.
291 MESSAGE: NM CAPABILITY REQUIRED TO SHOW OTHER'S
TRANSMITTED JOBS. (INT=291)
CAUSE: The user’s logon account doesn’t match the specified in the SHOW
command or NRJEHJInfo intrinsic.
ACTION: A user must have NM capability to manipulate jobs submitted
outside the logon
UserName.AcctName .
292 MESSAGE: EITHER USERNAME OR JOBLIST MUST BE SUPPLIED.
(INT=292)
CAUSE: Neither a
UserName nor a list of host job names and numbers
was supplied to the SHOW command or NRJEHJInfo intrinsic. One or the
other must be supplied.
ACTION: Make sure that either a
UserName or JobList is supplied and
that
UserNameLen or JobListLen is greater than 0 (NRJEHJInfo).
293 MESSAGE: STARTPOS MUST BE GREATER THAN 0. (INT=293)
CAUSE: The
StartPos parameter to NRJEHJInfo must be greater than
or equal to 1.
StartPos is out of range.
ACTION: Make sure the value is in range.
294 MESSAGE: DISALLOWED CONSOLE COMMAND STRIPPED FROM
JOB STREAM. (INT=294)
CAUSE: Users without NM capability are allowed to insert in a job
stream only those host commands specified in the configuration file.
ACTION: No action is required.
295 MESSAGE: CONFIGURATION FILE ACCESS ERROR. (INT=295)
CAUSE: The SHOW command or NRJEHJInfo intrinsic was unable to
access the workstation information. A more specific configuration file
error message should follow this one.
ACTION: Determine the cause, if possible, by inspecting the message
that follows this, and correct the problem. If the problem still occurs,
contact your HP representative for assistance.
296 MESSAGE: CONFIGURED JOBLOG BELONGS TO ANOTHER
WORKSTATION. (INT=296)
CAUSE: A job log file label specifies the workstation that owns the job
log. The configuration file specifies the job log file that each workstation