SNA NRJE Node Managers Guide (30292-90007)

Appendix A 165
Result Codes and Messages
SNA NRJE Error Messages
ACTION: Correct the punch destination.
255 MESSAGE: FORMS DESTINATION MUST BE LESS THAN 86
CHARACTERS. (INT=255)
CAUSE: The forms destination for SUBMIT or NRJE2Submit must be
between 1 and 86 characters if one is supplied.
ACTION: Correct the forms destination.
256 MESSAGE: OUTPUT DESTINATIONS MAY NOT RESOLVE TO SYSTEM
FILES. (INT=256)
CAUSE: The print, punch, or forms destination resolved to $
FileName .
This is not supported in NRJE II.
ACTION: Correct the output destination.
257 MESSAGE: INVALID OUTPUT DESTINATION BACKREFERENCE.
(INT=257)
CAUSE: A non-alphanumeric character was found in an output
destination backreference.
ACTION: Correct the output destination.
258 MESSAGE: UNABLE TO WRITE JOBLOG RECORD TO SPOOL FILE.
INPUT FILE #!. (INT=258)
CAUSE: A file system related error. A file system error message will
appear after this message.
ACTION: Determine the cause by inspecting the file system error
message and correct the problem.
259 MESSAGE: FILE SUBCODE OUT OF RANGE — INPUT FILE #!.
(INT=259)
CAUSE: The subcode of an input file must be between 0 and 2. The !
parameter is the file number in order input to SUBMIT or NRJE2Submit.
ACTION: Correct subcode array element to a value within range.
260 MESSAGE: RECORD TYPE OUT OF RANGE — INPUT FILE #!.
(INT=260)
CAUSE: A severe error has occurred.
ACTION: See “Problem Resolution” in Chapter 5 , “SNA NRJE
Troubleshooting,” of this manual, and contact your HP representative
for assistance.
261 MESSAGE: NRJE2SUBMIT INTERNAL ERROR. (INT=261)
CAUSE: A severe error has occurred.
ACTION: See “Problem Resolution” in Chapter 5 , “SNA NRJE
Troubleshooting,” of this manual, and contact your HP representative
for assistance.