SNA NRJE Node Managers Guide (30292-90007)

144 AppendixA
Result Codes and Messages
SNA NRJE Error Messages
78 MESSAGE: WORKSTATION READER IS DOWN. (SUB=78)
CAUSE: The workstation reader is not available.
ACTION: Determine whether the workstation is active.
79 MESSAGE: NM CAPABILITY REQUIRED FOR COMPRESSED FILE.
(SUB=79)
CAUSE:
ACTION:
81 MESSAGE: ATTACHIO FAILURE IN CONSOLE PROCESS. (CI=81)
CAUSE: A call from the console process to the system internal intrinsic
ATTACHIO failed to execute properly. Internal error.
ACTION: Contact Hewlett-Packard.
82 MESSAGE: FAILED TO ARM ABORT TRAP IN CONSOLE PROCESS.
(CI=82)
CAUSE: Internal error. A call to the system intrinsic XDSNTRAP failed.
ACTION: Contact Hewlett-Packard.
83 MESSAGE: FILE SYSTEM ERROR IN CONSOLE PROCESS: ! (CI=83)
CAUSE: Internal error. The console process could not access a needed
file.
ACTION: Use the VERSION command to verify the NRJE installation. If
versions are correct, contact Hewlett-Packard.
84 MESSAGE: CANNOT WRITE TO STDLIST FROM THE CONSOLE
PROCESS. (CI=84)
CAUSE: Internal error.
ACTION: Contact Hewlett-Packard.
85 MESSAGE: THE HOST CONSOLE IS OPEN. (CI=85)
CAUSE: The CONSOLE command executed successfully.
ACTION: None.
86 MESSAGE: THE HOST CONSOLE IS RELEASED. (CI=86)
CAUSE: The RELEASE command executed successfully.
ACTION: None.
87 MESSAGE: CONSOLE CANNOT BE ACCESSED UNTIL THE
WORKSTATION IS ACTIVE. (CI=87)
CAUSE: The CONSOLE command was issued but the workstation is not in
session with the host.