SNA Link/iX Node Managers Guide (30291-90009)

Chapter 3 95
Logging Configuration
Configuring Logging
Fields
Path
For display only. The NMMGR path to this screen. It
includes the names of the subsystem and the logging
class you are enabling users for.
Enable Console Logging?
Required. Enter Y if you want logging events for
only
this subsystem and class
displayed at the HP 3000
console; N, otherwise.
Refer to Table 3-1 for guidelines.
Note that if the value you enter here is different from
the value specified for this subsystem and class on the
“IBM Logging Configuration (1)” screen, the “IBM
Logging Configuration (2)” screen, or the “IBM Logging
Configuration (3)” screen, the value on the other screen
is overridden by the value you enter here.
Default: N
NOTE If you change the console logging configuration for any subsystem, the
changes will not take effect until the
entire HP 3000 system is shut
down and restarted.
Enable Disc Logging?
Required. Enter Y if you want logging events for
only
this subsystem and class
recorded in the NM log
file; N, otherwise. The file name that Node Management
Services (NMS) uses is NMLG
nnnn .PUB.SYS, where nnnn
is a number from 0000 through 9999 . This is a common
file used for logging by all logging classes in all
subsystems. At each MPE system startup, or when a
file is full, NMS creates a new NMLG
nnnn .PUB.SYS file,
naming each successive file by incrementing
nnnn .
When NMLG
9999 .PUB.SYS is full, NMS names the next
file NMLG
0000 .PUB.SYS. The MPE commands
RESUMENMLOG, SHOWNMLOG, and SWITCHNMLOG are used
to control logging and the log file. These commands are
described in Chapter 6 , “MPE Commands,” in this
manual.
Refer to Table 3-1 for guidelines.
Note that if the value you enter here is different from
the value specified for this subsystem and class on the
“IBM Logging Configuration (1)” screen, the “IBM
Logging Configuration (2)” screen, or the “IBM Logging