SNA Link/iX Node Managers Guide (30291-90009)
Table Of Contents
- 1 SNA Links Overview
- 2 SNA Node and Link Configuration
- 3 Logging Configuration
- 4 SNA Node Startup and Shutdown
- 5 SNA Link Troubleshooting
- 6 MPE Commands
- 7 SNA Link Installation Information
- A Messages
- SDLC Link Startup Error Messages
- SDLC Link Driver Error Messages
- SNACONTROL Error Messages
- SNA Transport Error Messages
- SNA Transport Logging Messages
- SDLC Link Shutdown Error Messages
- X.25 Link Failure Error Codes
- X.25 Link Module Configurator Error Codes
- X.25 Link QLLC Internal Error Codes
- NetView Alerts Error Messages
- Network Dump Manager Error Messages
- LAN Error Messages
- B Netview Alerts

274 AppendixA
Messages
LAN Error Messages
ACTION: If this error persists, check network components (adapters,
cables, MSAUs, etc.). Have your network provider examine the
network.
2103 MESSAGE: Token Ring adapter detected a soft error on LINKNAME
CAUSE: This station has detected an error and notified the Ring Error
Monitor.
ACTION: If this error persists, query your Ring Error Monitor to
determine the type of error. Check network components (adapters,
cables, MSAUs, etc.). Have your network provider examine the
network.
2104 MESSAGE: Token Ring adapter beaconing on LINKNAME
CAUSE: This station has stopped receiving data.
ACTION: If this error persists, then verify that all stations are
configured to the proper data rate. Check network components
(adapters, cables, MSAUs, etc.). Have your network provider examine
the network.
2105 MESSAGE: Token Ring adapter detected lobe cable fault on
LINKNAME
CAUSE: An open or short circuit was detected in the lobe cable.
ACTION: Verify that this station is properly attached to the network.
Check network components (adapters, cables, MSAUs, etc.). Have your
network provider examine the network.
2106 MESSAGE: Token Ring adapter auto-removed from network on
LINKNAME
CAUSE: This station detected an error.
ACTION: Verify that this station is properly attached to the network.
Verify that all stations are configured to the proper data rate. Check
this station’s station address. Check network components (adapters,
cables, MSAUs, etc.). Have your network provider examine the
network.
2107 MESSAGE: Token Ring adapter removed from network on LINKNAME
CAUSE: The Network Manager has requested that this station be
removed from the network.
ACTION: Verify that this station is properly configured. Query your
Network Manager to determine why this station was removed. Check
network components (adapters, cables, MSAUs, etc.). Have your
network provider examine the network.
2108 MESSAGE: Token Ring adapter detected no other stations on
LINKNAME
CAUSE: This is the only station on the network.