SNA Link/iX Node Managers Guide (30291-90009)

Appendix A 253
Messages
LAN Error Messages
LAN Error Messages
Listed below are the messages that are generated by the token ring
driver or token ring card. Depending on the logging configuration for
the Token Ring Link subsystem, these messages are logged to the
console, to disk, or both. These messages have the following format:
Internal driver error in SYSLINK (LANWARN ####) or
(LANERR ####)
where #### is an error number. The messages are listed in numerical
order according to the error number.
2 MESSAGE: Bad LINK ID.
CAUSE: An invalid LINK ID was passed to the link driver’s write
initiator.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard support contact.
CAUSE: An invalid LINK ID was specified in the rendezvous request
message.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard support contact.
3 MESSAGE: Bad OPEN ID.
CAUSE: An invalid OPEN ID was specified in the rendezvous request
message.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard support contact
5 MESSAGE: Unable to obtain a buffer manager buffer.
CAUSE: The buffers are not freed.
ACTION: Warmstart the system and correct the user programs.
CAUSE: Some other process has obtained buffers reserved for the driver.
ACTION: Write down the error information displayed on the console,
take a system dump, submit an SR, and call your Hewlett-Packard
support contact.
6 MESSAGE: Unable to obtain an I/O Services message frame.
CAUSE: The driver could not obtain a message frame from a user port
for newly arrived LAN packet (or from CAM’s port, in the case of a CIO
card) for a new DMA request to the card.
ACTION: Write down the error information displayed on the console,
take a system dump, submit an SR, and call your Hewlett-Packard
support contact.