SNA Link/iX Node Managers Guide (30291-90009)

220 AppendixA
Messages
SNA Transport Error Messages
SNAERR 103 MESSAGE: Invalid session control protocol. (SNAERR 103)
CAUSE: An invalid sequence of session control events has occurred.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 104 MESSAGE: RQR request pending. (SNAERR 104)
CAUSE: An attempt to send a ReQuest Recovery (RQR) request was
made while in a state other than reset.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 105 MESSAGE: STSN request not pending. (SNAERR 105)
CAUSE: A response to a Set and Test Sequence Numbers (STSN)
request is being sent, but no corresponding STSN request has been
received.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 107 MESSAGE: Unsupported CRV request/response. (SNAERR 107)
CAUSE: An attempt to send a CRyptography Verification (CRV) request
or response was made.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 108 MESSAGE: Unsupported session control request. (SNAERR 108)
CAUSE: An attempt to send an unsupported Session Control (SC)
request was made.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 109 MESSAGE: Unsupported session control response. (SNAERR 109)
CAUSE: An attempt to send an unsupported Session Control (SC)
response was made.
ACTION: Write down the circumstances and call your Hewlett-Packard
support contact.
SNAERR 110 MESSAGE: No such deactivation request (UNBIND,DACTLU,DACTPU)
received. (SNAERR 110)
CAUSE: An SNA service is trying to send a response to a deactivation
request (UNBIND, DACTLU, or DACTPU), but no such deactivation
request has been received.
ACTION: The SNA service should examine the situations in which a
deactivation response is sent, and verify that a response is sent only
after a deactivation request has been received.