SNA Link/iX Node Managers Guide (30291-90009)

186 AppendixA
Messages
SDLC Link Driver Error Messages
1035 MESSAGE: No TAB data structures available.
CAUSE: Top-plane Activity Block (TAB) internal data structures are
used whenever the driver tries to start new hardware activity. A limited
number of these data structures are available. Unexpected use of an
incorrect port and subqueues might have created excessive pending
hardware activity. This problem can also occur if a buffer manager
buffer could not be obtained.
ACTION: Unsupported programs must not contact the driver through
incorrect subqueues. This problem should produce a dump. Keep the
dump file along with the error information displayed on the console, call
your Hewlett-Packard support contact, and submit an SR.
1036 MESSAGE: Download file is incorrect for this driver.
CAUSE: The hardware was successfully downloaded, but the
downloaded code is for a different driver. A download file might have
been incorrectly renamed to have the name of the file expected by the
driver, or your download file or installed driver might be extremely old
and not matched.
ACTION: Run NMMAINT to verify the version of the download file
(PSISDLC0.PUB.SYS or PSISDLC1.PUB.SYS) and driver
(WANSDLCVERS). If the file is incorrect, try to restore a copy from a
system backup tape. If this does not solve the problem, you might have
to update your system and download file. Call your Hewlett-Packard
support contact.
1037 MESSAGE: Download file is too old for this driver.
CAUSE: The hardware was successfully downloaded, but the revision of
the download file cannot be used with the version of the corresponding
installed driver because their interfaces are incompatible.
ACTION: Ensure that the latest download file (PSISDLC0.PUB.SYS or
PSISDLC1.PUB.SYS) was restored during a recent system update. If not,
try restoring the file from a system backup tape. If this does not solve
the problem, you might have to update your system and download file.
Call your Hewlett-Packard support contact.
1038 MESSAGE: Unable to obtain a buffer manager buffer.
CAUSE: Terminating user programs have not freed buffers or buffer
pools they were using.
ACTION: Warmstart the system and correct the user programs.
CAUSE: Some other process has obtained buffers reserved for use by the
driver while the driver was trying to initialize itself.
ACTION: Try restarting the driver. If repeated link restarts fail, a
system dump will be required. Call your Hewlett-Packard support
contact.