SNA Link/iX Node Managers Guide (30291-90009)

Table Of Contents

166 Chapter6

MPE Commands

SNACONTROL TRACEON

displayed, and the command would have to be reissued with the proper

NODE=

NodeName

parameter included.

SNACONTROL TRACEON;LINKTRACE=,TF01

Partial (the default) link-level tracing is to be started for the only active

SNA node, and the trace data is to be written to the ﬁle TF01. Note that

if more than one node was active, this command would not be valid: A

list of conﬁgured nodes would be displayed, and the command would

have to be reissued with the proper NODE=

NodeName

parameter

included.

SNACONTROL TRACEON;LINKTRACE=;INTRINSIC=LU02

This command is not valid because the equal sign is speciﬁed with the

LINKTRACE

parameter, but no values are speciﬁed after it (the equal

sign should be included only if one or both of the values after it are

speciﬁed); an error would occur.