NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 6 99
Using NETTOOL
Using the NETTOOL Tools
PROBESTAT Use to display probe statistics for inbound and
outbound packets for the network specified by niname.
If you have not set niname, you will see statistics for all
NIs.
ARPSTAT Use to display ARP statistics for the network specified
by the niname command. If you have not set niname,
you will see statistics for all NIs.
UDPSTAT Use to display global UDP statistics or to report UDP
sockets statistics information for the network specified
by niname. If you have not set niname, you will see
statistics for all NIs.
filters Select to see current filter settings for this menu. Also
displays the global settings (INFILE, OUTFILE,
messages flag, data flag, and menus flag)
niname Use to set the name of the network interface for the
ARPSTAT, IPSTAT, PROBESTAT, TCPSTAT, and
UDPSTAT commands to act upon. The default is @
(display statistics for all NIs).
lkname Use to set the name of the link for the LKSTAT
command to act upon.
detail Use this toggle to specify the level of detail that the
program will display. If this filter is set, the program
will display full statistics for the link. If it is not set, the
program will display only summary statistics.
refresh Use to set the number of times the program will display
statistics before returning control to you. Default is one
cycle. (
[CONTROL]-Y will also return control.)
delay Use to set the number of seconds which will be inserted
as a delay after each statistics display. If the refresh
filter is set to a value of 1, the delay filter has no effect.
If you enter the delay command and press [RETURN],
the default value of 1 second is set.
Note that the delay time is in addition to any
processing time for the program. That is, setting a
delay of 1 does not guarantee that the statistics
measurements will occur at one second intervals. You
should view this parameter as a means of causing
successive measurements to be space by at least the
delay time.
recent Use this filter to select whether the displayed statistics
will be adjusted to show only the data which occurred
recently. If the flag is not set (the default), the program
will display all statistics totals.