NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 3 45
Getting Information About the Network
Displaying Status Information
To Display Status of a NET
To display the status of a NET configured as LAN1, enter the following
command at the MPE prompt:
NETCONTROL STATUS;NET=LAN1
To Display Status of an NI
To display the status of an NI configured as LAN1, enter the following
command at the MPE prompt:
NETCONTROL STATUS;NI=LAN1
To Display Protocol Status
You can display the status of a general protocol (TCP or PXP), or of a
network interface protocol (PROBE, ARP, IP, DIAL or X25) by using the
PROT= keyword.
To display the status of the ARP protocol on the LAN1 NI, you would
enter the following command at the MPE prompt:
NETCONTROL STATUS;NI=LAN1;PROT=ARP
To Display Network Services
For the Network Services, you can display the status of users, services,
or servers.
To Display Active Services
To display the services that are currently enabled on the local node,
enter the following command at the MPE prompt:
NSCONTROL STATUS=SERVICES
To Display Active Users
To display the number of active users of the Network Services on the
local node, enter the following command at the MPE prompt:
NSCONTROL STATUS=USERS
To Display Servers
The servers are the processes that are available to control the network
services. You may need to alter the minimum or maximum number of
servers available.
To see status information about the available servers, enter the
following command at the MPE prompt:
NSCONTROL STATUS=SERVERS