NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

22 Chapter1
Overview of NS 3000/iX Operations
Operating Your Network
Operating Your Network
You perform most of the daily operations required by the NS network
through the use of the provided NS 3000/iX network commands.
Complete information on the syntax and function of all the commands
is contained in Chapter 7, “Commands,” of this manual.
The NETCONTROL START command allows you to initiate the network
transport as well as the individual networks on an active transport.
The NETCONTROL STOP command allows you to stop an individual NI
or all active entities of the network transport.
To start and stop the Network Services after the network is started, you
use the NSCONTROL START and NSCONTROL STOP commands. The
NSCONTROL ABORT command is useful when you need to terminate
services immediately.
See Chapter 2, “Operating Your Network,” for step-by-step instructions
for using these commands.