NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 7 171
Commands
SWITCHNMLOG
SWITCHNMLOG
Closes the current log file and creates and opens a new one.
Syntax
[UPDATE ]
SWITCHNMLOG [filenumber]
Use
Available In Session? YES
In Job? YES
In Break? YES
Programmatically? YES
Breakable? NO
Capabilities? NM
Parameters
UPDATE Allows you to update logging configuration for all
subsystems actively logging without stopping
transport. To change the logging configuration, use the
node management configurator (NMMGR). Refer to the
NS 3000/iX Screens Reference Manual or to the
HP 3000/iX Network Planning and Configuration
Guide for more information on configuring logging.
Once changes are made, issue the SWITCHNMLOG
UPDATE command so that the changes take effect.
The UPDATE option may not be used with the filenumber
option.
filenumber Switches the log file to a file with the specified number.
The value for filenumber must be an integer from 0 to
9999. For example,
SWITCHNMLOG 10
makes NMLG0010 the current log file. If you specify a
number that is already being used, then the next
available consecutive number is used.
The filenumber option may not be used with the UPDATE
option.