NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

160 Chapter7
Commands
NSCONTROL STATUS
NSCONTROL STATUS
Displays information about the Network Services.
Syntax
[=USERS ]
[=SERVICES]
NSCONTROL STATUS [=SERVERS ]
[=ALL ]
[=SUMMARY ]
Parameters
STATUS Displays information about the Network Services. Can
be used to check if the Network Services were
successfully initiated, or to check on the current status
using the following parameters:
USERS Displays the sessions on the node that
are associated with the Network
Services.
SERVICES Displays information about the
services.
SERVERS Displays information about the servers.
SUMMARY Displays a summary of the information
about services, servers, and users.
ALL Displays all available information
about services, servers, and users.
You can qualify the STATUS function with one
parameter or with a list of parameters separated by
commas.
Default: ALL
Discussion
This function displays information on those local sessions that were
created by a DSLINE and REMOTE HELLO and on those remote sessions
that were created by a REMOTE HELLO. The STATUS display does not
list information on either local sessions that are using DSCOPY without
a REMOTE HELLO or temporary remote sessions created by NFT, RFA,or
RPM.
The following examples show the information provided by the STATUS
function of the NSCONTROL command.