NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

156 Chapter7
Commands
NSCONTROL START
NSCONTROL START
Enables the Network Services.
Syntax
NSCONTROL START[=service[,service]…]
Parameters
START[=services] Enables the NetworkServices (VT, Reverse VT, NFT,
RFA, RDBA, RPM, LOOPBACK, and NSSTAT). The first
START creates the Network Services control process,
called DSDAD. The optional service list (services) allows
you to select which of the services are enabled for local
or remote use.
Default (if the service list is omitted): enables all
services for both local and remote use.
The services which allow users on remote nodes to use
resources on the local node are as follows:
LOOPBACK Allows remote users to use the
loopback diagnostic server on the local
node.
NFT Allows remote users to transfer files to
or from the local node using the
DSCOPY command and intrinsic.
NSSTAT Allows remote users to use the
NSSTATUS intrinsic to retrieve network
services information from the local
node.
RFA Allows remote users to access files on
the local node, using the RFA and RDBA
services.
RPM Allows remote users to create and kill
processes on the local node using the
Remote Process Management service.
VT Allows remote users to logon to a
session on the local node.
VTR Allows remote users to access local
terminals using the Reverse VT
service.