NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

150 Chapter7
Commands
NSCONTROL LOG
NSCONTROL LOG
Enables or disables detailed event logging for the Network Services.
Syntax
[{,ALL } ]
{ON } [{,RPM } {,LOW} ]
NSCONTROL LOG={OFF} [{,ENV } {,HIGH}]
[{,DSDAD } ]
[{,VTSERVER} ]
[{,DSSERVER} ]
Parameters
LOG Enables or disables NMS logging of Network Services
detailed events, configured as SUB0006, CLAS0004 in
the NMCONFIG.PUB.SYS configuration file. Detailed
events are only used for troubleshooting and are
normally disabled.
ON Enables detailed logging of the
specified Network Service modules.
OFF Disables detailed logging of the
specified Network Service modules.
For each Network Services software module, two levels
of event logging are provided. These are HIGH, which
logs all events, and LOW, the default, which logs a
subset of the events, as specified below.
ALL LOW—Logs LOW events for all modules.
HIGH—Logs HIGH events for all
modules.
RPM LOW—Logs RPMCREATE and RPMKILL
requests.
HIGH—Same as LOW.
ENV LOW—Logs environment information
from DSLINE and REMOTE HELLO
commands.
HIGH—Same as LOW, plus environment
table locking and use counts.
DSDAD LOW—Logs creation and deletion of
sockets, ports, and server processes.