NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 7 149

Commands

NSCONTROL LOADKEYS

Loads the Network Services command keywords.

Syntax

NSCONTROL LOADKEYS

Parameters

LOADKEYS Loads the Network Services command keywords from

the ASCAT.NET.SYS catalog. You need to use this

command only if the catalog is modiﬁed, such as for

localization.

Discussion

The LOADKEYS function is only used to switch between pre-prepared

ASCAT.NET.SYS catalogs. When the node is initiated, the Network

Services command keywords are automatically loaded into an extra

data segment from the ASCAT.NET.SYS catalog. This is done to ensure

fast access to the command keywords during command parsing.

However, it might be useful to have commands in the appropriate

language of the installation. If so, the LOADKEYS function is used to

reload the alternate catalog into the extra data segment without having

to coolstart the system. Make a copy and a listing of the catalog before

switching catalogs.

Example

:HELLO MANAGER.SYS,NET

Logon to the NET group in the SYS account

:RENAME ASCAT,ASCATOLD

Rename the old catalog.

:RENAME ASCATNEW, ASCAT

Substitute the new catalog for the old

:NSCONTROL LOADKEYS

Reload the catalog.

NOTE

If an NSCONTROL command reports CIERR 5077, follow this example to

restore the old ASCAT catalog and contact your HP representative for

assistance.